Welcome to GLEERIDE Learn more

*Please choose and purchase according to local laws and policies.

Free shipping on all ebikes & e-scooters.

We are coming!

Gleeride was born to take responsibility for your ride. Save 3% Off Code

GR3

ASOMTOM WHALE eBike Unbox & Assembly

ASOMTOM WHALE eBike Unbox & Assembly

ASOMTOM WHALE ebike features a sturdy rear cargo rack, providing ample storage. With its durable design and reflective strip detailing, it ensures both practicality and safety.

What's in this box?

It has charger x 1, user manual x 1, pedals x 2, pump x 1, lock x 1 and the tools needed for setup.

eBike Installation Steps

Install the rear wheel

  • Take the bike out of the box and position the bike so the derailleur is not directly touching the ground.
  • Remove the rear wheel nut, washer, and tape holding the pin.
  • Locate the indicator arrow on the tire. Make sure the direction of the arrow matches the direction of the tricycle.
  • Align the tire and insert it accurately into the bearing slot.
  • Install the washer and nut.
  • Repeat the above steps for the other side.
Install the fork and handlebars

  • Remove the tape used to secure it.
  • Take out the two fittings on the fork.
  • Lift the body of the bike and insert the fork into the head tube. Make sure the black fork bridge faces the outside of the bike.
  • Place the spacer ring with the small opening facing down on the fork. Then put the protective cover on.
  • Insert the handlebar into the fork tube. Secure the handlebar with the screws. Put on the dust cap.
  • Connect the motor wires as per the arrows. Then snap the motor wires into the fixing slots.
  • Adjust the position of the handlebar and tire.
  • Align the bike's handlebars with the front wheel, making sure it is vertical.
  • Tighten the stem screw on the right side of the handlebar.
Install the front and rear brakes

  • Remove the screws that hold the fork in place.
  • Pull off the brake caliper's fasteners.
  • Align the brake disc and install the brake caliper.
  • At the same time, hold the left front brake handle with your hand and tighten the screws by hand.
  • Install the rear brake caliper using the same procedure.
  • Squeeze the right rear brake handle and flip the switch to lock the rear wheel.
  • Tighten the brake caliper on the rear wheel!
Install the taillight and pedals

  • Please install according to the left and right markings on the pedal.
Install the front rack and headlight

  • Remove the screws securing the front frame.
  • Install the headlight to the front frame.
  • Remove the screws securing the frame.
  • Cross the tightening screws.
  • Connect the headlight wires.
Install the front fender

  • Install the front fender bracket first.
  • Then install the screws above the fender.
Install the rear rack

  • Be careful to distinguish the front and back of the rear frame.
  • Remove the nuts and washers on the rear screws of the chassis.
  • Fix the 4 screws in the rear holes of the chassis.
  • Tighten all four screws with a wrench.
  • Align the fender with the three holes and insert.
  • Place the side of the frame bag without the reflector near the seat.
  • Fix the frame bag.
Inflate the tires with a pump

  • Please check the air pressure of the three tires. And inflate under-inflated tires.

Now that you have completeargod the assembly of your ASOMTOM WHALE Cargo ebike, it’s time to riding with Gleeride!

 

Leave a comment

Please note: comments must be approved before they are published.

Back to the top