Please check this safety checklist carefully before riding your Baolujie electric bike.
SAFETY CHECKLIST
Before every ride, it is important to carry out the following safety checks:
1.Brakes
Ensure front and rear brakes work properly.
Ensure brake shoe pads are not over worn and are correctly positioned in relation to the rims.
Ensure brake control cables are lubricated, correctly adjusted and display no obvious wear.
Ensure brake control levers are lubricated and tightly secured to the handlebar.
2.Wheels and tires
・ Ensure tires are inflated to within the recommended limit as displayed on the tire sidewall.
・ Ensure tires have tread and have no bulges or excessive wear.
・ Ensure rims run true and have no obvious wobbles or kinks.
・ Ensure all wheel spokes are tight and not broken.
・ Check that axle nuts are tight. If your bicycle is fitted with quick release axles, make sure locking levers are correctly tensioned and in the closed position.
3.Steering
Ensure handlebar and stem are correctly adjusted and tightened, and allow proper steering.
Ensure that the handlebars are set correctly inrelation to the forks and the direction of travel.
Check that the headset locking mechanism is properly adjusted and tightened.
the If bicycle is fitted with handlebar end extensions, ensure they are properly positioned and tightened.
4.Chain
Ensure chain is oiled, clean and runs smoothly.
Extra care is required in wet or dusty conditions.
5.Bearings
Ensure all bearings are lubricated, run freely and display no excess movement, grinding or rattling.
Check headset, wheel bearings, pedal bearings and bottom bracket bearings.
6.Cranks and Pedals
Ensure pedals are securely tightened to the cranks.
Ensure cranks are securely tightened to the axle and are not bent.
7.Derailleurs
Check that front and rear mechanisms are adjusted and function properly.
Ensure shift and brake levers are attached to the handlebar, shift and brake.
Ensure derailleurs, shift levers and shift and brake cables are properly lubricated.
8.Frame and Fork
Check that the frame and fork are not bent or broken.
either If are bent or broken, they should be replaced.
9.Accessories
Ensure that all reflectors are properly fitted and not obscured.
Ensure all other fittings on the bike are properly and securely fastened, and functioning.
Ensure the rider is wearing a helmet.
10.Motor Drive Assembly and Throttle
Ensure all motor drive components are correctly mounted and functioning properly.
11.Battery Pack
Ensure the batteries are in good operation condition and kept fully charged.